Epsom 01372 747 177
Battersea 0207 223 4729
East Sheen 020 887 887 95
Rollerblinds

How do I install my roller blind?

{ Video Coming Soon }
 

How do I take my roller blind down?

{ Video Coming Soon }
 

My side roller blind will not roll up all the way.

This could be due to slight slippage on the control causing the join in the chain to block the operation. Take the roller blind down and roll the fabric up by rotating it by hand then replace the roller blind.

Venetian Blinds

How do I install my venetian blind?

{ Video Coming Soon }
 

How do I take my venetian blind down?

{ Video Coming Soon }

Vertical Blinds

How do I install my vertical blind?

{ Video Coming Soon }
 

How do I take my roller blind down?

{ Video Coming Soon }
 

One of my vanes won't turn

Pull the chain control until the vanes are aligned, then carry on pulling until you hear a clicking noise, (don’t worry this is the cams aligning). This should solve the problem.

Motorised Roller Blinds

My electric motorised roller blind won't work

Check the cables from the plug to the transformer, the transformer to the receiver and the receiver to the blind and make sure they haven’t been disconnected. Then check the following:
  • Has the cable to the blind been damaged?
  • Is it plugged in?
  • Is the socket turned on?
  • Does the socket work? Plug in another appliance to test
  • Does the remote control light up when you press the button? If not replace battery
  • Re-program the remote control (see here).

Awnings

My electric motorised awning won’t work

Check the following:

  • Has the cable to the awning been damaged?
  • Is it plugged in?
  • Is the socket turned on?
  • Does the socket work? Plug in another appliance to test
  • Does the remote control light up when you press the button? If not replace battery
  • Re-program the remote control

How do I clean the awning fabric?

This can be washed with a mild detergent and a brush
 

How do I remove my valance?

First remove the two end caps at both ends of the front profile. You will see a cross head screw in the valance heading slot. Loosen the screw both ends then slide the valance out of the profile – then re-fit end caps.
 

Back To Top